Retrofit fuel, route and engine-health advice for Philippine passenger boats.
Starting the optimiser…
Sim mode
Sim:
Offline Mode Active
Windy.com Live Weather Studio
Rec. Throttle
—%
Saving at Rec.
—L/h
Actual Speed
0.0kts
Awaiting Start
ETA Target
--mins
Time Remaining
--:--
0.0
Expand 2D
BEFORE DEPARTURE
Enter a whole number between 0 and the certificated capacity.
Crossing time must be greater than zero.
HOW TO RUN A VOYAGE
Set the two ports. Click the map to drop the departure pin, then the destination pin. The pathfinder replans on every change.
Describe the vessel. Open the vessel panel and enter length, beam, draft, capacity and engine rating. Every fuel and speed figure is derived from these — defaults are a generic 120 t ferry.
Choose the conditions. Pick a weather preset, or Live conditions at vessel position to pull the real sea state at the boat's coordinates.
Add hazards. The obstacle and storm tools place avoidance zones. Click an armed tool again to put it away.
Get under way. Enter the passenger count and target crossing time, and the console solves for the throttle that meets it.
Reading the numbers
Every recommendation comes from the optimiser, not from a language model. Where a value is unavailable the console shows a dash rather than a guess — a dash means the optimiser was not reached, and it is a real state worth reporting.
If the requested crossing time is faster than the hull can achieve in the current sea, the console says so and reports the time it can make instead.
ENGINE TELEMETRY & DIAGNOSTICS
Predictive Maintenance SystemAwaiting data
BRIDGE
Select a system to list its components. Bars show remaining service life.
Engine--
ComponentLife scoreTime to failure
Assessment resolves once the engine has run-hours.
AI Analysis
--
Anomalies
None recorded for this system.
Recommended Action
--
Historical dataset
CSV. Column headers may be ISO 19848 DataChannelIDs such as
/main-engine/cooling/fresh-water/temperature,
or plain names like coolant_temp_c.
Include rpm, wave_height_m
and heading_deg so conditions are known —
without them the models cannot learn what weather explains.
No dataset imported. Condition models are fitted from this session only.